I upgraded my 9400 to the latest firmware.
Since doing so I get 'Command Failed' at the top of the screen.

This doesn't always happen.

It appears that when the remote has not been in use for a few minutes it happens for the first command.

Anyone else getting this.

I was having this problem with the older FW last week at a client's house. I haven't had a chance to troubleshoot it as yet.

In this particular case I had to change the channel to 2 to deal with some interference issues. I might try channel 3 to see if this improves things.

If you figure it out first, please let us know.

Dawn

Interesting. I just noticed this yesterday as well, but wrote it off to a fluke or minor RF interference of some kind. Anyway since you are reporting this I will test it again this evening when I get home to see if it indeed the issue repeats itself. If so, I would have to agree with you that the firmware upgrade may have brought another issue to the surface.

I haven't noticed any problems, but it seems to take slightly longer for my test 9400 to connect to the access point.

You have not said what you are trying to connect to. If it is an extender, turn it off and on, as well as your 9400 off and on.

Hi, didn't think of that.

Just tried it - TSU9400 off - 60 secs, RFX9600 off - at least 15 secs.

Powerd both up.
Waited for TSU9400 to boot and connect.
Pressed MUTE - (link to Receiver Mute using IR)

Command Failed.

Repress - Works immeadiately.

Still got the problem.
At some point over the next week I'll find the previous firmware.
I must get it on to see if it is that or another issue.

Note: I'll also create a new config with one IR command.

I have put the original firmware (V3.0.15) back on the unit.

Just finished some more testing.

The problem has not been resolved.

I will look elsewhere.