For the last two weeks I have been trying to get my 9400 to connect to my 9600.

Unfortunately, all the remote does is show the words "CONNECTING" in the top left hand side of the screen (next to the home button).

Before I go into detail, I am correct it my assumption that, when successfull connection is made the word "CONNECTING" will be replaced with "CONNECTED"

Mark

It will be replaced by the name of the device currently open (typically Home). You will also see "Comamnd Failed" if a command does not get executed after connection.

Hello,

I too had this problem and it turned out that I was using an incorrect security setting on my WAP/router. Once I changed my router to use WEP, my TSU9400 connected just fine. I hope this fixes it for you too.

Chris.

Many many thanks for the replies.

Bingo, it was the WEP settings, my router was on (I think) WPA-ESK or something similar.

It works, I'm really please can't wait to input some RS232 codes and, who knows maybe, eventually get round to some PS writing to receive feedback from my devices

Once again many thanks to those who replied

All the best
Mark