Your Universal Remote Control Center
Crestron Control Systems Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Crestron DMPS-300C IR Input
This thread has no replies.
Post 1 made on Saturday May 5, 2018 at 02:57
Lurking Member
May 2018
I have a dmps-300-c processor and I am trying to use the Ir input to receive commands from a RC5 remote. I am just using a cheap Ir receiver that I am sure is connected correctly ( tip-signal, ring-+5v and sleeve is ground ) I am fairly new to simpl but this is what I have done so far:
I have assigned the rc5/universal remote driver to the C2l-DMPS-IR-INPUT slot 5
According to instruction all I have to do is compile/send then go to toolbox/system info/functions/identify transmitter and I should see the Ir codes transmitted by the remote, but nothing.. I have tried all sorts of options but I am slowly going crazy.
Any help would be very much appreciated.
Kind regards

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse