Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Dimming LED Lighting ( Bulbs ) in Complete Control ( CCP ) with URC 600M or 6MLV
This thread has no replies.
Post 1 made on Friday September 2, 2022 at 09:19
PTotaro
Junior Member
Joined:
Posts:
November 2019
15
The minimum load requirement for these dimmers are 60 watts for the 600M and 40 watts for the 6MLV. The 6MLV may dim LED's better because of the lower minimum load requirement. Theses dimmers do not need a neutral wire.

Just an FYI, the URC switch S6AM has a minimum load requirement of 10 Watts and a neutral wire is needed.

The higher the load (watts / number of bulbs) of the LED lighting you are trying to control, the better your dimming results will be.

Using a Lutron LUT-MLC (resistor) will let the led bulbs turn completely off and help with dimming a little (got me to about 50% before flickering the bulbs). If your only problem is the bulbs not turning completely off, a LUT-MLC shoild fix that. Others have also suggested using a 1.5 kOhms ±1% 25W Wirewound Chassis Mount Resistor (RH0251K500FC02 / KAL25FB1K50 )

Using a Lutron LUT-LBX Synthetic Minimum Load For use with Reverse and Forward Phase Dimmers will let the led bulbs turn completely off and help with dimming better than the LUT-MLC. The LUT-LBX got my LED bulbs dimming down to about 15% with no flickering. EBay is your cheapest bet for the LUT-LBX. The LUT-LBX requires a double gang box for in-wall or surface mounting, but can be added anywhere after the dimmer switch and the first lamp.

I did some bench testing with a 600M dimmer (I did not have a 6MLV to test) and a LUT-LBX with about 5 different dimmable LED bulbs from different manufactures and different styles to test the minimum load needed for the bulb to dim without flickering and turn completely off. All bulbs dimmed down to about 15% with no flickering and turned completely off with 16 watts of load. Some of the bulbs went as low as 6 watts of load before a slight flickering.

So if you want to use LED lighting with Complete Control (CCP) and a 600M or 6MLV dimmer with good results, you will need a Lutron LUT-LBX.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse