Post 1 made on Wednesday December 16, 2009 at 10:27 |
kadiddle Long Time Member |
Joined: Posts: | December 2009 10 |
|
|
So far it doesn't look like this is possible. I want to take a command from an activity macro, such as "Display page 1 of Watch TV" and assign it to a button. I would like to also be able to copy all of the action steps from an activity and assign them to a button somewhere else. Sure, I know how to assign general commands to a button and copy them to other buttons, but some of the commands are only created when a macro is created like in the example above. Any ideas? kadiddle
|
|
Post 2 made on Wednesday December 16, 2009 at 11:24 |
dalto Long Time Member |
Joined: Posts: | July 2005 435 |
|
|
I don't think you can that with the mx-810. The page jumps can only be done by the activity wizards.
|
|
Post 3 made on Wednesday December 16, 2009 at 13:28 |
Eastside A/V Select Member |
Joined: Posts: | September 2006 1,782 |
|
|
|
OP | Post 4 made on Wednesday December 16, 2009 at 13:38 |
kadiddle Long Time Member |
Joined: Posts: | December 2009 10 |
|
|
Thanks, I didn't think it was possible but wanted other opinions. kadiddle
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.