Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


MSC - 400 Problems with IR in macros
This thread has 1 response. Displaying all posts.
Post 1 made on Wednesday October 14, 2009 at 14:53
Lurking Member
September 2009
I have MX-880 remotes and a MSC400. I have an old Denon 3803 receiver. It works fine with the MX-880 sending a RF signal through the MSC400. However, I programmed a Smart Macro in the MSC-400 and am having problems with it. I see the IR emmitter flash as the macro runs, but the Denon 3803 does nothing. I then tried controling it with the MX-880 (i.e. still via RF, but without any macros) and it worked fine. I'm pretty sure that the IR emitter seemed to light up a little longer this way.

All my other components work fine with the SmartMacro. Any ideas on how to fix this?
Post 2 made on Thursday October 15, 2009 at 21:35
Select Member
September 2009
Did you call universal about this problem? Noticed nobody has responded to your problem yet.
Better days are ahead
Better days are ahead

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse