| Post 1 made on Wednesday February 20, 2008 at 22:38 |
cb1 Select Member |
Joined:
Posts: | September 2002
1,663 |
|
|
Went to clients house today and none of his 4 remotes would execute any macros, went to rack and the emitters were flashing, as was the blue status light on the 400. Unplugged unit then plugged it back in, worked fine after that.
Has this happened to any of you? What would cause it? I have only done a few of these, dont know how often this may happen. Thanks
|
why have a nice system if you cant operate it, program the remote the right way the FIRST time! |
|
| Post 2 made on Thursday February 21, 2008 at 15:32 |
Alan Wood Lurking Member |
Joined:
Posts: | December 2007
1 |
|
|
Unfortunately this has happened three times in my system over the past month. It appears to happen when I hold the volume button(s) down to raise or lower the volume. I am using an MX-980 remote.
|
|
| OP | Post 3 made on Friday February 22, 2008 at 20:46 |
cb1 Select Member |
Joined:
Posts: | September 2002
1,663 |
|
|
hmmm< this system has two 950's and two 3000's
|
why have a nice system if you cant operate it, program the remote the right way the FIRST time! |
|
| Post 4 made on Wednesday February 27, 2008 at 16:36 |
Hannalee Long Time Member |
Joined:
Posts: | August 2007
24 |
|
|
what was the condition of the 2 status lights on the antenna?
|
|
| OP | Post 5 made on Wednesday February 27, 2008 at 19:27 |
cb1 Select Member |
Joined:
Posts: | September 2002
1,663 |
|
|
normal< one red the other doing nothing
|
why have a nice system if you cant operate it, program the remote the right way the FIRST time! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
