| Post 1 made on Thursday January 10, 2008 at 14:03 |
mccoady Founding Member |
Joined:
Posts: | July 2001
136 |
|
|
Just got my 810 but have never programed a pc remote before. Going through the Device setup I have a RPTV which there is a category for but not my outboard HD tuner (Zenith), my tv is old enough the HD tuner was not built-in so what do I do about this?
By the way all my Devices have the audio and video ran through my Outlaw 990 Preamp/Processor.
|
|
| Post 2 made on Thursday January 10, 2008 at 14:11 |
Surf Remote Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
I would set up the HD tuner as if it were a cable box or satellite device.
Mike
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
| OP | Post 3 made on Thursday January 10, 2008 at 17:51 |
mccoady Founding Member |
Joined:
Posts: | July 2001
136 |
|
|
Thanks Mike I hope this isn't over my head to program I'm having a hard time figuring out how to set this up with the Outlaw actually already doing all the switching instead of having to switch each device to a different tv input.
The way the Outlaw works is when pushing each device button on the Outlaw remote it turns on the Outlaw itself and switches to that device input. There is no ON button on the Outlaw remote since each device turns the Outlaw on while the Power button is strictly a OFF button.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
