Is there anyway within an executing a macro and following a step GOTO Page... which jumps to new device / page to have a second macro (on the destination device / page) automatically kicked off. The macro commands one the second macro would reflect the RF / IR settings for the destination device / page rather than the RF / IR settings of the original device page.

What I am trying to do is have a main page represent zones in the house. Each zone would then have sub menu configured via a dummy device / pages to act as menu. From the zone level menus I would map to specific devices applicable to that zone. Most of the components are in a closet and using the msc 400 to control a number of the components. I want to issue RF commands specific to each zone on a different port on an MSC 400. It appears that the RF configuration is device specific and cannot be change at a command level within a macro (say as you can with RTI).

Any suggestions would be appreciated