Post 1 made on Thursday February 4, 2010 at 18:18 |
mostasz Long Time Member |
Joined: Posts: | February 2010 36 |
|
|
I got this setup recently. Everything works good with LG TV, but does not always work fine with Motorola DVR cable box. MRF 260 is about 2 feet away from DVR, MRF switch is set to 1. I'm using only RF. Everything is programed in CCP
Q1: I think IR blaster is disabled, since I'm sending commands trough RF, correct? I cant see any IR coming from MRF(using digital camera)
Q2: I copied VOL, and Mute buttons from TV page, to Cable page, so when I'm in cable I'm controlling cable. Seems like punch trough did not work. Can I setup punch trough for vol buttons to control TV while watching Cable? Because of that I had to setup Cable commands going to all RF gateway outputs, instead out going to Cable box flasher.
Q3: Trick with Menu, Power, Power worked for me as long as DVR received IR signals. Problem is, that even when flasher flashed, not every signal was recognized/received by DVR. For example: only one of two consecutive POWER commands, separated by 0.2 delay was received. I tried IR set to max, min, and about half way on adjustable IR out of gateway. Any suggestions?
|
|
|