I have been experiencing this issue as well. Started happening with the updates prior to the latest ones just released. Have had several close calls per blowing my speakers to kingdom come due to this. Fortunately I can set a maximum volume limit per the A/V receiver, so I've set that accordingly. I'd also note that I've experienced this issue just as many times when I didn't happen to be ramping my volume. Either the message just comes up on its own or after pressing a given button. The message will continue to come up each time I attempt to send a signal from the remote until I reset the remote which resolves the issue. I'd simply roll back to the prior firmware, but the version I'm running addresses a memory leak issue, so its been worth the trade-off.