Post 1 made on Thursday October 22, 2009 at 14:45 |
Knightwing Long Time Member |
Joined: Posts: | March 2007 322 |
|
|
I am using a T2C with a RP-1, and a Xantech 283 blink emitter. I can't seem to get consistant channel macro's to work. The HR21 will usually miss the first # in the macro. I am using the HR20-700s (clean) codes at this point. Tried no repeats and also turning DOWN the output on the RP-1. I currently have an EXTRA .2 sec delay between the #'s this is in addition to the "built in" .3 sec of delay.
It is working "good" at best, but not reliable enough for the client at this point.
I have had no troubles with the HR20 but this is my first? HR21. The hard # buttons seem to work without issue.
What is the secret?
|
|
|