Wondering if anyone has run into this problem... I have set up small macros to change the channel on my Direct TV HD DVR.... You press the TV Logo and it goes to the channel... Simple enough.... Here is the issue... It worked fine for all my Direct TV receiver, except the HD DVR... It would hesitate, etc... I though it was my program, however, my macro worked fine on every other receiver.... Today, I just switch out one of the receivers that it did work on and replaced it with a new Direct TV HD DVR (HR-23).... Now the same issue is occurring with the new HD DVR... So, this confirms that the problem is with the HD DVRs.. I have tried putting in delays between each number of the channel i have tried putting in a delay at the beginning... Nothing seems to be working... Has anyone had a similar issue... If so, what was the right timing combination to fix it?