Hi, I am very new to this, my previous remote was a Harmony 895

I'm struggling to get RS232 command from my remote (TSU9400) to my Amplifier (Cambridge Audio 640R)

I can tell from my RFX9600 LED's that the extender is receiving the codes from the remote and sending them to the RS232 outport that I have specified.

The code that I am inputing to turn the Amp on (as a test to see if things work is)

#1,01,1\r

This command, is meant to turn the Amp on and, is taken from here

[Link: cambridgeaudio.com]

I'm not sure what I'm doing wrong, I'm using a 3m serial RS232 Female - Female cable I have also used the "Arrow" button to enter the "Backslash" "\r" bit at the end of the code.

Like I say the LED's on the RFX9600 indicate that a command has been received and, has indeed been processed by RS232 port 1 (I.E the one I have assigned).

Any help would be greatly appreciated
Mark

PS I have

Baud Rate of "9600"
Parity of "None"
Data Bits "8"
Stop Bits "1!