Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 10 made on Friday September 22, 2006 at 04:11
Active Member
September 2006
Yes, that was my expectation that the MRF-300 would be an upgrade. Thanks for the sanity check.

The fact that address 0 is behaving better is probably an indication that there isn't RF interference, but something wrong inside the MRF-300 box itself. RF interference that occurs every 5 seconds or so should be readily apparent on either the antenna or the 300. But if the MRF itself is dropping or corrupting the data internally, it could randomly decide the data is meant for a different unit and cut off the flasher.

I suppose it's possible the unit might even be interferring with itself, such that when a lot of data is received is when it's most likely to corrupt or drop data.

Hosting Services by ipHouse