On September 20, 2006 at 15:04, Surf Remote said...
The MRF needs to be on an ID other than "0" to enable
individual IR routing. On "0", all emitters receive any
command from the remote. The 850's not going anywhere
for awhile and it will work with an MRF-350, it's just
that the narrow band RF of the other remotes above it
will give you better reliability of RF performance.
Mike
www.SurfRemoteControl.comSaw this thread and purchased the mx-350 and the mrf-250.
Set the 250 on channel 2 and have 4 emitters.
Set the 4 SAT devices in the 350 to channel 2 and to transmit RF only and to only emit 1,2,3,4 respectively.
I get no blinking on the status light of the 250 when pressing buttons on the 350.
When I switch the base (250) to channel 0, I do get blinking lights but, as stated, all emitters work and I don't want that.
What am I doing wrong here?
Want to control 4 SAT boxes...
Thanks