Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Sunday September 3, 2006 at 14:17
Long Time Member
March 2003
Yesterday, when i was trying to finish up at a clients house i noticed that the remote wasn't functioning like i thought that i had programmed it so i plugged it back into the laptop and went to upload to fix it and the MX3000 editor wouldn't open? It would get almost open and say it had encountered a problem and then shut down. Then after it had closed i would get a microsoft .net fault which would then close the conplete control software? I can open and work on all of the other remotes just not the MX3000? Today for the last 5 hours or so i've uninstalled everything including .net and reinstalled with no success. I've tried cleaning out the registry after uninstalling and just about everything i can think of. Any ideas? Anybody? I've got two to get done by tomorrow and another two to do on tuesday so needless to say this sucks right now!

Hosting Services by ipHouse