Post 1 made on Thursday October 5, 2006 at 21:36 |
seat850 Lurking Member |
Joined: Posts: | October 2006 1 |
|
|
Hi All,
I was reprogramming my faithful MX700 today, and the device got an "abort retry fail" connection error during the process, and now the device is stuck in a testing loop and I can't seem to make it stop. I have taken the batteries out for a while, replaced them with new ones, made sure I don't have a stuck button, with no success.
What I see is the normal LCD testing that goes on when you install batteries, but as the test ends (all tests pass with "GOOD!", btw) and you see the word "skip" in the lower right, it just goes right back to the test, over and over. I can't reporgram, as it won't exit the test loop. The only way to stop it is to remove the batteries. Any ideas on how to solve this?
Thanks!
Craig
|
|
|