Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 3 made on Monday November 13, 2006 at 23:17
Long Time Member
February 2004
Are you "testing" only, or did you down load to the MSC? I found a similat problem when testing a keydigital piece. The MSC assumes all baud rates are 9600 UNTILL you download. Even though you may set it correctly in the setup and test screens, untill you load it into the MSC, the baud will be stuck at the default 9600. Load the project with the corrected baud rate and re-try the test. Hope this helps.

Hosting Services by ipHouse