On August 31, 2006 at 17:41, jbwood1 said...
Hello! I am just starting to program an MSC-400 / MX-3000
pair and have a question about how to assign the RF ID's.
I have 12 devices that I intend to control via ports 1-12
w/ IR flashers on the MSC-400. In the MSC-400 documentation
it says that on ID's 10 and above can address ports 7-12
via IR, so far so good.
In the MX-3000 Editor, the RF Receiver ID's only go up
to F, and can only address lines 1 to 6.
I don't see an intuitive way to assign MX-3000 devices
to the appropriate RF ID to address all 12 ports on the
MSC-400??
I'm sure I am missing something, but can't seem to resolve
the discrepancy...
This is because everyone wanted the MSC to start shipping sooner than it was supposed to so here you are...In the Field Beta , the issues will be taken care of like KC had mentioned in a future update