Guys,

I have programmed T1000's, 2000's and now been programming my 3000 for a while. All of this usually trouble free, but now I seem to have something either very stupid on my part, or very strange going on.

I have a PFC for my 3000 that I have been working on and am seeing links change from to point to something else after I save and reload my PCF file. I had recently started programming the 3000 on a new machine and setup a fresh install there and every else seemed fine. However, I noticed that the links were changing between file saves. If I save the file and keep working, the one in memory is fine. However, if I reload the newly saved one from disk, all of the links now point to other actions. I just downloaded and installed the latest NG Edit and firmware updates but they didn't help.

Has anyone seen this? It is occurring 100% of the time, so I know it must be something I have done, but can't tell what that is.

Thanks in advance!!!!!!!!!!!!!