Post 1 made on Monday September 16, 2002 at 22:04 |
MrEos Long Time Member |
Joined: Posts: | September 2002 10 |
|
|
What am I doing wrong? When I import bmp's, and then try to select one from the properties bitmap tab, all of the bitmaps (or only some of them, occasionally) are not visible. My blind clicking success ratio is only about 35%, so that doesn't qualify as a workaround.
Another error I sometimes get in this process is a pop up message that says part of the "you have successfully imported a gallery" message, but keeps popping back up when I click "ok." Sometimes it will go away after 15 or so clicks, usually I give it the three finger salute, losing unsaved changes. Again, not an acceptable workaround.
Am I alone on this? Can someone state the proper way to import and use bmp's.
Best regards...
|
|
|