Daniel, Here are the codes for up/down and left/right below. Do they look dirty to you? I've read the faq but still can't really tell. Pressing and holding any of the buttons causes a continual scroll, just like the factory remote, and tap scrolling works, its just not snappy. My guess is they're probably o.k., but I've relearned them again, just to be sure. The tap-scrolling response is still the same.
The inability of the Neo (or RC 5400 which I also have and does the same thing) to tap scroll as fast as the factory remote probably is a result of some parameter in the firmware that causes a one second or so minimum IR burst and is, as you say, unchangeable.
From what I’ve read here and elsewhere on the Internet, people usually don’t have this problem. Instead, they need the IR burst to be longer and more continuous so the device receiving the signal will accept the command. Everything I’ve read is about lengthening the min. IR burst, not shortening.
I bet this longer-than-a-standard-remote bursting feature is a good thing most of the time, especially with macros as it no doubt ensures that the commands the learning remote sends get received.
Let me know what you think of the codes below, and, if you hear any more on this topic, please let me know. It’s certainly not very important, but I appreciate the help nonetheless.
