| Post 9 made on Sunday September 15, 2002 at 20:40 |
Ahl Founding Member |
Joined:
Posts: | October 2001
1,241 |
|
|
I've done it before.... I did an installation where half the components were in the bedroom with the tv, but were blocked by the bed, and the other half were installed in the bathroom closet...
I used one Xantech target, two 'brains', one 9 volt, the other 12 volt... I got power for the target from the 12v emitter which was in the closet, and tapped in the 9v brain for the bedroom components in the 'ground' and 'signal' spots, leaving the 9v pole open...
Works like a charm.
It may not fit your application, but this example shows that it can be done :)
| |
|
We can do it my way, or we can do it my way while I yell. The choice is yours. |
|
