Many thanks john, the codes worked out well.

now... For what happened on the job.....

I used these codes my Keypad with the T2 Toggle Macro. Keypad worked pretty reliably. Hicupped a little bit but thats not the strange part.

When I built my macros they were not working at all. after much experientation, I found that using alternating groups workes 80% of the time.. so my macro looked like this

0e
1o
0e
1o
enter-e

This set Camera 1 to Output one. where
0e
1e
0o
1o
enter-e

didnt work at all.

Finally, I added a "dummy" code pre macro steps so an odd key sequence was always the last sequence seen before the macro and they started working 95%. (5% is due to the fact that the switcher seem to react too slow to change outputs with 10 seconds of a previous command)

Just thought I'd throw that out there and see of it made any sense to someone.