Post 14 made on Thursday September 23, 1999 at 13:25 |
Roland S Historic Forum Post |
|
|
I recently introduced my friend to X-10. He has already went gung-ho and replaced practically every switch in his house.
He has noticed that all the lights in a particular room have problems turning most of the time. This only occurs when it is initiated by a macro (computer interface). Lights turn on fine via remote. Yes, this sounds like a typical phase jumping problem.
The thing is that when he turns on his stove (electric) or clothes dryer (electric), neither helps. He also has a hottub (220V) in which the water circulator is constantly on.
The house is less than 2000 s.f.
I'm stumped. I had the same problem (i.e. macro vs remote), but when a 220V appliance was turned on, it was fine.
He is going ahead and installing the Leviton 6299 Signal Bridge. I think it may work.
Any other possible causes or suggestions?
Roland
|
|
|