Post 1 made on Tuesday December 30, 2003 at 17:51 |
jedgeco Founding Member |
Joined: Posts: | January 2002 7 |
|
|
I am attempting to install a 3-way Switchlinc slave/master system. I got both of the switches installed, threw the breaker, and now have the following happening:
1) My slave switch doesn't work at all. 2) The master will turn the lights on, but it buzzes a lot and when the lights get to full brightness, it either cuts them off or dims back down until they're off. 3) My IR543 will turn the lights on, but again when they get to full brightness, they cut off.
Anybody have any suggestions? I think that the problem might lie somewhere in the neutral wire hookup for the master switch. Any advice would be greatly appreciated. Thanks!
|
|
|