Post 1 made on Tuesday May 16, 2006 at 16:52 |
ELA Long Time Member |
Joined: Posts: | December 2005 238 |
|
|
I am looking for an X-10 compatible switch (wall mount) that will send "device code" - "on" when pushed and held, and then send "device code" -"off" when released.
An x-10 push-on "momentary switch" ?
Does anyone know if this is available? I have read about programmable switches that are pretty expensive. I was hoping for a simpler alternative.
I am yet to add a controller to my X-10 setup so I cannot use a macro at this point.
This would be to send a command to a drapery motor to open/close. I want to avoid having to push on and push off. I would rather push-hold and then release. I do not want to have to remember to turn off the power once the motor has reached its end of travel.
Regards, Ela
|
|
Ela |
|