Bought a Pronto last week. Programmed it all up and almost everything works.

What doesn't work is all 5 of the right-side physical buttons. The buttons themselves can be sensed by the Pronto because learning codes for them seems to work normally, and after going to Use mode, the little "IR out the top" animation says the Pronto is sending, but there's no effect on the target device.

Learning the same code into an on-screen button, or one of the two bottom physical buttons, works fine.

Any ideas? I downloaded the ProntoEdit SW but don't have a cable yet.

------------------
Craig MacKenna
Los Gatos, CA