Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 4 made on Friday October 8, 2021 at 05:26
Barf
Long Time Member
Joined:
Posts:
August 2013
325
In IrScrutinizer: for the "Protocol", select "RC5" from the pull-down menu. In IrScrutinizer, that protocol has two parameters: D (device), and F (function). From the context, we conclude that

Address: 13h (group 19: Pre-Amp2)

means that D=19 (or 13 in hexadecimal). It is the parameter that is constant for all commands. You can enter either form; using the prefix "0x" to indicate hecadecimal (as in the sceendump).

In the same way, the command number is the "F", enter as decimal or hexadecimal as you like. After entering protocol and parameter values, just press "Render". (Earlier versons said "Generate" instead of "Render".)

(Strictly speaking, there is a toggle parameter ("T") too, but for most purposes, you can just ignore it.)

The full manual is available here: [Link: harctoolbox.org]


Hosting Services by ipHouse