Your Universal Remote Control Center
Original Equipment Remotes Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Saturday October 3, 2020 at 15:35
Lurking Member
November 2015
I have a Directv RC66 (non-genie remote). I wish to setup the volume for an ARCAM AV40. The remote is setup for IR (not RF). I have done this with any other remotes from Directv so I'm not sure what is different...

1. I go to the settings and program AV1 and it finds the code and the Vol+/- works. This all works as expected.
2. I acknowledge this in the Directv menu, it all seems ok.
3. I then switch the remote to AV1 and the volume doesn't work, but the RC66 lights indicate it's sending a code.
4. as a result, volume punch through doesn't work either

What gives?

Hosting Services by ipHouse