Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 10 made on Tuesday June 9, 2020 at 00:42
Junior Member
June 2020
I am using my iPhone to power it on and off. The path is basically iphone - Global Cache IP2IR - Buffalo IR hub - Xantech Relay - Amp. MyCFAVisit

So the iPhone sends the command via IP over wifi to the IP2IR device which converts the signal to IR. At this point it is passed through the IR hub to the Xantech relay which triggers the amp on and off.

Last edited by gudgeonjf on June 10, 2020 00:42.

Hosting Services by ipHouse