Hi All,

My setup has been going great for years, until I decided to add my new Amazon Fire Stick and accidently pulled a emitter wire too hard!!!!

I suspect the broken wires shorted my RFX9600's emitter outputs as if the RFX9600 is connected to my Xantech block, none of my IR emitters operate.

If I connect an emmitor directly to the unit, it does flash however fails to control anything!

Question 1: has anyone tried to repair a RFX9600 board?

Question 2: I have been told that next time I need to install a diode between RFX9600 & Xantech block, Has anyone done this?

Any help would be appreciated.

Many Thanks
Daniel