Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Thursday April 16, 2020 at 23:37
Junior Member
April 2020
I have an MX-980 and I use CCP to program.

I have a main MRX-1 basestation with the RF250 IR sensor and a secondary basestation MRF-260 that I use to control the projector rather than running a flasher over to the projector.

the AVR Arcam AVR390 and Tivo run off the MRX-1 and the Projector is Epson 5040ub on the MRF-260

So as you would expect I have the tivo, the arcam, and the projector as separate devices. Tivo and arcam specified as MRX-1 and projector as MRF-260 in the RF section of CCP.

Where I am running into an issue is when I try to make a macro to turn everything on or off. It does not seem like I can get a macro to execute commands to both base stations. When I make macros I am using alias to the projector off and alias to the receiver off button. Do I need to "jump" to the projector page first ?

thanks in advance for any help

Hosting Services by ipHouse