On April 5, 2016 at 12:31, weddellkw said...
The warnings/notices are telling you that your logic signals aren't actually connected to anything:
-the on/off signals should connect the output of a stepper to the corresponding inputs on your projector module.
-the on_fb/off_fb signals need to be driven by the corresponding _fb output signals on the projector module.
-the tx$/rx$ strings carry the control data between the projector module and the serial port, and need to be connected on both.
Generally speaking, 'signals' will exist on both the input and output sides of symbols, thus linking them together.
You can highlight a signal and press F2 to view where it originates and lands.
Leaving 'open' signals is bad practice.
Not exactly. There will not be signals on both input and output all the time in fact with smart graphics, not near as much as before.
Leaving open signals is just fine unless you're taking a master class. His list of signals with no driving force or destination will cause ZERO issues. If you don't want these messages to show up, put those signals on a buffer with // on the enable line.
If the system isn't working properly, then look at these signals and see what they're for.
