Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 3 made on Friday September 28, 2012 at 09:24
Super Member
March 2008
On September 28, 2012 at 08:10, danieljanderson said...
I have experienced similar issues in the past.
In these instances I've found that if I put the troubled command as the first step, it works.

The problem with this is turning stuff on out of sequence and shouldn't need to be done. I'm assuming that the codes on page 4 were there before and you just copied over them? Have you tried deleting the alias to power in the macro and re-adding it again? Can't explain why but many times that seems to work in CCP (it is a crappy piece of software )
"Quality isn't expensive, it's Priceless!"

Hosting Services by ipHouse