The following page was printed from RemoteCentral.com:
Post 1 made on Friday June 4, 2010 at 06:38 |
inpowers Long Time Member |
Joined: Posts: | January 2007 35 |
|
|
Hi All I have been doing allot of research on this problem and unable to find a answer. I have run into a hole here. My problem is that I am using the Pronto TSU9600 with the RFX9600. I am using the RS232 for the Yamaha RX-V2700 for controls. Yes I have made up the serial cable with terminals 2 to 3 and 3 to 2 and 5 to 5 with 7 & 8 shorted out at the AV side. All works well except I can't turn the unit On. If the unit is turned on manually and I push a button on the remote the function then works. It show on the amp power on but when in the off state I can't turn it on. I have tried a 0.50sec delay but with no success. Hex code that that is being used is 02 30 37 41 31 44 03. Any help will be much appreciated.
Rob
|
|
|
|