Post 1 made on Tuesday August 17, 1999 at 11:42 |
Brian Porter Historic Forum Post |
|
|
I am living in an older apartment complex which is only wired with 2 wires and does not have a ground pin on the electrical outlets.
I would like to employ X10 for some simple lighting controls using plugin modules, but I am not sure if X10 will work without an available ground pin. Will the signal be sent without it??
|
|
OP | Post 2 made on Tuesday August 17, 1999 at 18:54 |
You will have no problem with X-10. The ground is, in most new homes, not even hooked up to the switchs, only the outlets. X-10 switches don’t have a place to hook up the ground anyway.
|
|
OP | Post 3 made on Tuesday August 17, 1999 at 18:58 |
Daniel Tonks Historic Forum Post |
|
|
Some of the fancier dimmer switches require a ground, so just make sure you check before purchasing. If it is required it'll most likely say so.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.