Your Universal Remote Control Center
RTI Control Systems Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


SSH/Telnet for switching?
This thread has no replies.
Post 1 made on Sunday December 3, 2017 at 22:27
Junior Member
November 2017
Does anyone know the proper driver or if there is even a driver for using ssh or telnet over RTI? I would like to be able to send commands to a switch for hdmi over IP routing using cisco switching. Not sure if this is possible but i have looked at using the HTTP authentication driver which i think is closer to what i need or i might just be implementing it incorrectly. Otherwise the 2 way string driver I figured might work well but again maybe implementing it wrong. would love some input if this has been done or if there is an easier way I have not tried. Thanks

This is what I am trying to send (all of the commands assuming the device has logged in already) obviously numbers are irrelevant

switchname: config
switchname: interface fe 10
switchname: switchport general allowed vlan remove 2-9
switchname: switchport general allowed vlan add 3 untagged
switchname: end


Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse