Post 1 made on Thursday September 14, 2017 at 14:30 |
Otter Long Time Member |
Joined: Posts: | April 2006 30 |
|
|
My IR commands work if I set them to standalone, but I am unable to get them working via the hard-wired IR/RS232 port... I tried setting the frequency to 0 on a few buttons and that didn't work either...
|
Dan O |
|
Post 2 made on Thursday September 14, 2017 at 22:38 |
Glackowitz RC Moderator |
Joined: Posts: | May 2002 3,793 |
|
|
The ir input is a stereo jack. Use tip for signal and sleeve for ground. Ring in the middle isn't used.
There should be an ir port and a 232 port.
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.