| Post 1 made on Wednesday December 30, 2009 at 18:18 |
nardo1 Active Member |
Joined:
Posts: | April 2005
628 |
|
|
I’ve started to bench test 2 way this week and I have ran into a problem that I can not figure out. I am able to get the conditional state of my buttons, (on, off, cool, heat) as well as drive commands but I am having a problem with displaying data. What I would like to display is the current temp as well as the heat set point and cool set point in the auto mode. I can not seem to figure this out. Currently I am using the default Oasis templets. Anyone able to point me in the right direction?
Thanks,
Bill
|
I'll let you know tomorrow.. |
|
| Post 2 made on Wednesday December 30, 2009 at 18:53 |
FASTLs Long Time Member |
Joined:
Posts: | October 2004
480 |
|
|
The heat and cool points are text variables. Go under edit text and then select the correct variable.
FASTLS
|
|
| OP | Post 3 made on Wednesday December 30, 2009 at 20:12 |
nardo1 Active Member |
Joined:
Posts: | April 2005
628 |
|
|
Got it. Thanks.
|
I'll let you know tomorrow.. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
