Post 1 made on Saturday January 29, 2000 at 19:04 |
mark truax Historic Forum Post |
|
|
does anybody have any ideas about how to switch the dtc-100 input with either discreet commands or strings of commands. i need to program a remote and the toggle function of the "input" button won't work the way i need it to.
|
|
OP | Post 2 made on Saturday January 29, 2000 at 23:27 |
considering that the HD input is only activated at the unit what's the point?
|
|
OP | Post 3 made on Saturday February 12, 2000 at 20:45 |
I would ike this also.. and the point is that OFF THE AIR sources require the HD mode switched via the menu not the front panel or remote. In other words, ifyou are on directv then you have to open the menu, switch source to off-air antenna a or b then channel switch to the HD off the air channel. A single remote code would be WAY WAY nicer.
|
|
OP | Post 4 made on Monday February 21, 2000 at 14:22 |
Walter Historic Forum Post |
|
|
Mark,
By "input" do you mean the antenna:sattelite INPUT that is on the RCA remote? IF so and if you have already tried to have another remote "learn" from that button and it didnt, try it again. I have seen a few times where the code learned was incomplete for some reason and doing it again corrected the problem.
If by input you mean antenna a:b switching try the antenna button on the remote.
Walter
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.