Post 1 made on Wednesday October 12, 2005 at 19:16 |
Chad Gauntt Lurking Member |
Joined: Posts: | October 2005 1 |
|
|
For the second time, the touchscreen on my prontopro just died. The picture is still there, it still beeps when I reset it, it just doesn't respond to any touch.
Anybody else experience this or know of a solution???
Any help would be greatly appreciated.
Chad
|
|
Post 2 made on Thursday October 13, 2005 at 00:13 |
bomberjim Super Member |
Joined: Posts: | September 2001 3,894 |
|
|
Try reflashing the firmware -- on the toolbar select "tools" and then update remote. You might also try recalibrating the screen. If these don't work, either it's a loose connection inside the remote (unlikely) or the screen is dead.
|
Jim L |
|
Post 3 made on Thursday October 13, 2005 at 22:05 |
Lyndel McGee RC Moderator |
Joined: Posts: | August 2001 12,992 |
|
|
Sounds like a loose cable inside. You might try http://www.joey6p.com to get some pointers on how to disassemble and check the cables. Please note that this site describes the process for the 1000/2000 remotes but the approach is very similar.
|
Lyndel McGee Philips Pronto Addict/Beta Tester
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.