| Post 1 made on Friday May 27, 2005 at 02:25 |
richie rodgers Lurking Member |
|
|
The back light on the touch screen doesnt work and i found out why. It needs a new part and I don't know where to get it. The circuit board inside the remote has a little black winding if i'm knot mistaken the board is labled L1 where the part goes I dont know the part # or where to get it can someone help me. Also just to let you know the vol. chanel and mute buttons do light up. The winding looks like a small black piece of ceramic wrapped with real thin copper wire and each end of the wire is solderd to the board which i managed to unsolder.I know this is the problem because it was hanging on by a thread and if you pressed on it or if it had some preassure on it then the light would work,but by troubleshooting i managed to knock it off.The remote works fine but no back light. Thanks for your help.
|
richie rodgers |
|
| Post 2 made on Friday May 27, 2005 at 11:49 |
bomberjim Super Member |
Joined:
Posts: | September 2001
3,894 |
|
|
A forum search reveals this is a common problem. Look here: [Link: remotecentral.com]. 220uH inductor seems to work best.
|
Jim L  |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
