Post 1 made on Saturday April 30, 2005 at 12:52 |
scooterJ Long Time Member |
Joined: Posts: | December 2002 20 |
|
|
opened up my pronto to check for loose wires and such. found 2 of the 3 screws on the back almost impossible to remove without stripping. pulled off the case and was about to remove the screws that hold the next board on...there are a possible 4...mine had only 2! The bottom 2! the light switch is toward the top, and upon inspection, it appears that the switch has shifted, I am going to put it all back to gether to see if the switch works now...if so I guess the missing screws was the culprit...what kind of company sells their products with missing (2 of 4) screws.
|
|
OP | Post 2 made on Saturday April 30, 2005 at 13:39 |
scooterJ Long Time Member |
Joined: Posts: | December 2002 20 |
|
|
well the backilght switch seems to be the problem...it has rotated 20 degrees, and though my eyes aren't good enough to see the connections, I suspect that at least one of them is toast.
Am I looking for a replacement switch, or simply a good re-solder job?
Thanks again Scott
ps...where are all my posts from 2002 and 2003?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.