Post 1 made on Sunday January 13, 2002 at 19:59 |
rar2000 Founding Member |
Joined: Posts: | January 2002 1 |
|
|
i got a neo, i upgraded the firmware and the neoedit. I have a panasonic 47 hdtv and i trying to teach the remote the PIP functons to the which it has a few but everytime i press the button it says that it failed i tried it many times but doesnt wanna pick up. i also have the same problem trying to teach it the directional on the hard button can anyone help???
|
|
Post 2 made on Sunday January 13, 2002 at 20:22 |
allamand Founding Member |
Joined: Posts: | October 2001 513 |
|
|
I have found that with some IR codes you have to just keep tring! Also, on my RCA utv I found out that by first holding the RCA remote's button, then quickly hit the NEo button I wanted the code learned to, that it learned the IR code great! So that's a option to try. Try looking for Ncf files with the code already learned too, as you can "Copy & Paste" them to your config.
-steve
|
-steve |
|
Post 3 made on Monday January 14, 2002 at 01:10 |
onion Founding Member |
Joined: Posts: | January 2002 32 |
|
|
I held down the button on the remote I was learning from for a few secs. then I het the button on the Neo that I wanted to learn. This worked about 70% of the time.
For the more stubborn ones I did this;
Move the Neo to the edge of the table with the ir window looking out off the edge, then take your old remote and lower it or raise it and point it at the Neo ir signal. Even turning it upsaid down when you do this. Just be sure and hold both it very still.
Hope this helps.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.