Post 1 made on Friday February 22, 2002 at 00:23 |
RWI Founding Member |
Joined: Posts: | December 2001 592 |
|
|
I have created my first macro and am having trouble, when I opened the first macro panel there is a delay, so I left it there, I added jumps to various soft buttons and tested it, it works as expected although the transmit remains lit and the remote locks up needing a hard reset to unfreeze it. What am I doing wrong?
|
|
Post 2 made on Friday February 22, 2002 at 09:34 |
allamand Founding Member |
Joined: Posts: | October 2001 513 |
|
|
Depends, if you are using the older firmware, one of the bugs was that the Neo locked up whenever a macro had a jump in it to another Device page!
So you might not be doing anything wrong! If you haven't installed the latest firmware yet, try that.
If you already do have 1.3.3.2 firmware, then I really can't say whats going on..
|
-steve |
|
Post 3 made on Sunday February 24, 2002 at 23:58 |
britfan75 Founding Member |
Joined: Posts: | February 2002 14 |
|
|
I continuously had this problem too, even with the upgrade. I had to change 2 things, and now it works fine.
1. always turn off your anti-virus software before you upload or download to the Neo.
2. the first step in the macro CAN NOT be a "beep" or a "delay". These must only be put in after you have programed at least one "command" code (i.e. an rf).
Jay
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.