Post 1 made on Saturday December 29, 2001 at 00:29 |
Mike Hood-Douda Founding Member |
Joined: Posts: | December 2001 4 |
|
|
I have a digital surround processor that is fed power from a switched outlet on my receiver. I need to send the dsp the correct Input select command depending on activity. My problem is that if the receiver is already on, and therefore the dsp is on, when I change activities, the Harmony sends the PowerToggle command to the dsp which shuts it off.
Would I edit the device xml, activity xml, or ??
-Mike
|
|
Post 2 made on Saturday December 29, 2001 at 01:31 |
Bob Ulius Founding Member |
Joined: Posts: | October 2001 91 |
|
|
I posted this over on the email group where you also asked the question but will copy my thoughts below:
I would think the easy way would be to re-characterize the DSP device and tell it that it has manual power. I do this a lot with devices that are auto on with my Monster power conditioners and triggered when the pre/proc turns on.
Let me know if the above doesn't make sense and I'll try to explain more fully.
-=Bob=-
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.