Your Universal Remote Control Center
Harmony Remote Controls Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Where to disable PowerToggle?
This thread has 1 response. Displaying all posts.
Post 1 made on Saturday December 29, 2001 at 00:29
Mike Hood-Douda
Founding Member
December 2001
I have a digital surround processor that is fed power from a switched outlet on my receiver. I need to send the dsp the correct Input select command depending on activity. My problem is that if the receiver is already on, and therefore the dsp is on, when I change activities, the Harmony sends the PowerToggle command to the dsp which shuts it off.

Would I edit the device xml, activity xml, or ??

Post 2 made on Saturday December 29, 2001 at 01:31
Bob Ulius
Founding Member
October 2001
I posted this over on the email group where you also asked the question but will copy my thoughts below:

I would think the easy way would be to re-characterize the DSP device and tell it that it has manual power. I do this a lot with devices that are auto on with my
Monster power conditioners and triggered when the pre/proc turns on.

Let me know if the above doesn't make sense and I'll try to explain more fully.


Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse