Post 1 made on Monday May 22, 2023 at 20:01 |
I have a client with a Elkomax TV Lift. The control unit Molex connection and RJ11. Does anyone know they pin out. On their site it has manual but doesnt tell me what pair is the ir Receiver or contact closer. I am tyring to program either a ir command to send the lift up with power on and close with power off. Anyone have any info on these units? This is the site [Link: elkomaster.com]
|
|
Post 2 made on Tuesday May 30, 2023 at 23:24 |
Ernie Gilman Yes, That Ernie! |
Joined: Posts: | December 2001 30,104 |
|
|
Look up how to solve a problem like this using a volt/ohmmeter. It's not too difficult but I don't have the time to type it out right now.
hint: when you locate two wires that have low resistance between them, then higher resistance if you reverse the connections, then you've found the wires going to the emitter.
|
A good answer is easier with a clear question giving the make and model of everything. "The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw |
|
Post 3 made on Friday June 2, 2023 at 06:19 |
If you're looking for information on the pinout of the Molex and RJ11 connections for the Elkomax TV Lift control unit, it would be best to consult the manufacturer's support or technical documentation. They should provide detailed information on the pin configuration and functionality of the connections. If the manual doesn't provide the specific details you need, reaching out to the manufacturer's customer support or technical team directly may be the most reliable way to obtain the required information. They will be able to assist you with programming the IR commands and provide any additional guidance you need for your specific setup.
|
|
Post 4 made on Sunday June 4, 2023 at 05:03 |
Germionatind Junior Member |
|
|
On May 22, 2023 at 20:01, c2tech said...
I have a client with a Elkomax TV Lift. The control unit Molex connection and RJ11. Does anyone know they pin out. On their site it has manual but doesnt tell me what pair is the ir Receiver or contact closer. I am tyring to program either a ir command to send the lift up with power on and close with power off. Anyone have any info on these units? This is the site [Link: elkomaster.com]
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.